Update printer.cfg

printer.cfg

@@ -89,12 +89,12 @@ enable_pin: !PE0
 rotation_distance: 40
 gear_ratio: 80:16
 microsteps: 16
-endstop_pin: ^PF2
+endstop_pin: probe:z_virtual_endstop
 ##  Z-position of nozzle (in mm) to z-endstop trigger point relative to print surface (Z0)
 ##  (+) value = endstop above Z0, (-) value = endstop below
 ##	Increasing position_endstop brings nozzle closer to the bed
 ##  After you run Z_ENDSTOP_CALIBRATE, position_endstop will be stored at the very end of your config
-position_endstop: -2
+#position_endstop: -2
 position_max: 340
 position_min: -5
 homing_speed: 5
@@ -166,7 +166,7 @@ stealthchop_threshold: 0
 
 [extruder]
 step_pin: printhead: PD0
-dir_pin: !printhead: PD1
+dir_pin: printhead: PD1
 enable_pin: !printhead: PD2
 rotation_distance: 8
 gear_ratio: 1:1
@@ -174,16 +174,17 @@ microsteps: 16
 full_steps_per_rotation: 200	#200 for 1.8 degree, 400 for 0.9 degree
 nozzle_diameter: 0.400
 filament_diameter: 1.75
-heater_pin: printhead: PA2
+spi_speed: 4000000
+heater_pin: printhead: PB13
 sensor_type: MAX31865
 sensor_pin: printhead: PA4
-spi_bus: spi1a
+spi_bus: spi1
 rtd_nominal_r: 1000
-rtd_reference_r: 430
+rtd_reference_r: 4300
 rtd_num_of_wires: 4
 min_temp: 10
 max_temp: 270
-max_power: 1.0
+max_power: 0.7
 min_extrude_temp: 170
 control = pid
 pid_kp = 26.213
@@ -202,7 +203,9 @@ stealthchop_threshold: 0
 
 [adxl345]
 cs_pin: printhead: PB12
-spi_bus: spi2
+spi_software_sclk_pin: printhead: PB10
+spi_software_mosi_pin: printhead: PB11
+spi_software_miso_pin: printhead: PB2
 axes_map: x,y,z
 
 #####################################################################
@@ -230,7 +233,7 @@ pid_kd: 363.769
 ##	Inductive Probe
 ##	This probe is not used for Z height, only Quad Gantry Leveling
 ##  NPN and PNP proximity switch types can be set by jumper
-pin: ^PF1
+pin: printhead: PB6
 x_offset: 0
 y_offset: 25.0
 z_offset: 0