diff --git a/printer.cfg b/printer.cfg
index 1f55f85..6e12de9 100644
--- a/printer.cfg
+++ b/printer.cfg
@@ -52,7 +52,7 @@ cs_pin: PC13
 spi_software_mosi_pin: PG6
 spi_software_miso_pin: PG7
 spi_software_sclk_pin: PG8
-run_current: 1.000
+run_current: 1.414
 stealthchop_threshold: 0
 
 # Y Stepper on Motor2 (A Motor)
@@ -76,7 +76,7 @@ cs_pin: PE3
 spi_software_mosi_pin: PG6
 spi_software_miso_pin: PG7
 spi_software_sclk_pin: PG8
-run_current: 1.000
+run_current: 1.414
 stealthchop_threshold: 0
 
 
@@ -109,7 +109,7 @@ cs_pin: PB9
 spi_software_mosi_pin: PG6
 spi_software_miso_pin: PG7
 spi_software_sclk_pin: PG8
-run_current: 0.8
+run_current: 1
 stealthchop_threshold: 0
 
 ##	Z1 Stepper - Rear Left on Motor5
@@ -126,7 +126,7 @@ cs_pin: PG14
 spi_software_mosi_pin: PG6
 spi_software_miso_pin: PG7
 spi_software_sclk_pin: PG8
-run_current: 0.800
+run_current: 1
 stealthchop_threshold: 0
 
 ##	Z2 Stepper - Rear Right on Motor6
@@ -143,7 +143,7 @@ cs_pin: PG10
 spi_software_mosi_pin: PG6
 spi_software_miso_pin: PG7
 spi_software_sclk_pin: PG8
-run_current: 0.800
+run_current: 1
 stealthchop_threshold: 0
 
 ##	Z3 Stepper - Front Right on Motor7
@@ -160,7 +160,7 @@ cs_pin: PD5
 spi_software_mosi_pin: PG6
 spi_software_miso_pin: PG7
 spi_software_sclk_pin: PG8
-run_current: 0.800
+run_current: 1
 stealthchop_threshold: 0
 
 #####################################################################
@@ -532,18 +532,19 @@ feedrate_splice: 0.3
 feedrate_normal: 1.0
 auto_load_speed: 2
 auto_cancel_variation: 0.1
+
 #*# <---------------------- SAVE_CONFIG ---------------------->
 #*# DO NOT EDIT THIS BLOCK OR BELOW. The contents are auto-generated.
 #*#
 #*# [input_shaper]
 #*# shaper_type_x = mzv
-#*# shaper_freq_x = 49.4
+#*# shaper_freq_x = 46.0
 #*# shaper_type_y = zv
-#*# shaper_freq_y = 62.0
+#*# shaper_freq_y = 59.0
 #*#
 #*# [probe]
 #*# z_offset = -1.875
 #*#
 #*# [extruder]
 #*#
-#*# [heater_bed]
\ No newline at end of file
+#*# [heater_bed]