diff --git a/kuukar/kuukar_config.py b/kuukar/kuukar_config.py
index c2a2b88..18ddfc5 100644
--- a/kuukar/kuukar_config.py
+++ b/kuukar/kuukar_config.py
@@ -1,6 +1,5 @@
-SERIAL_MCU = "/dev/serial/by-id/usb-Raspberry_Pi_Pico_E660B4400771212A-if00"
-SERIAL_DRV = "/dev/serial/by-id/usb-Raspberry_Pi_Pico_E6609CB2D3846033-if00"
-SERIAL_LCD = "/dev/serial/by-id/usb-Silicon_Labs_CP2102_USB_to_UART_Bridge_Controller_0001-if00-port0"
+SERIAL_MCU = "COM4"
+SERIAL_DRV = "COM20"
 
 # HC Sonar Pins
 SONAR_1_ADC_PIN = 0
@@ -35,3 +34,5 @@ REVERSE_LEDS = [11, 10, 9]
 LIGHT_ANALOG_PIN = 2
 
 DHT22_PIN = 14
+
+SERIAL_LCD = "COM9"
diff --git a/rpi_install.sh b/rpi_install.sh
index 8b44167..55e45f6 100644
--- a/rpi_install.sh
+++ b/rpi_install.sh
@@ -1,10 +1,6 @@
-echo "Updating Software Repository"
 sudo apt update
-echo "Installing Dependencies"
 sudo apt install python3 python3-pip
 pip3 install -r ./requirements.txt
-echo "Creating systemd Service"
 ln -s ./kuukar.service /etc/systemd/system/kuukar.service
 sudo systemctl kuukar enable
-sudo systemctl kuukar start
-echo "Installation Completed!"
\ No newline at end of file
+sudo systemctl kuukar start
\ No newline at end of file